Profit Ladder Mt5 EA

This is not an aggressive, high yielding EA but targets between 100% - 200% annually so as to keep drawdown as low as possible. However, to increase target, you may increase MM until you get desired result. 

EA default setting is recommended for H1 timeframe of GBPUSD but can be optimized for other pairs and timeframes as well.

PARAMETERS: 

1. UseFixedLot: By default, this is set to false, meaning you are using growing lots based on available capital and MM setting. If you prefer to use fixed lot size, set this to true.

2. FixedLotsize: Ignore this if you're not using fixed lot size. If using fixed lot, ensure the value you set here is commensurate with your available capital.

3. MM_Percent: Money Management - Default value is set to 5. Higher value means higher stake.

4. MM_Denominator: Default value is 1,000. Your Account Balance divided by MM_denominator multiply by MM_Percent determines your lot size per trade.

5. MinLot: This is used to set your preferred minimum lot size.

6. MaxLot: This is used to set your preferred maximum lot size.

7. UseInbuiltExit: This can be set to true or false

7. Stop Loss: Pip value is used. EA will recognize your broker's digits automatically.

8. Take Profit: Pip value is used. EA will recognize your broker's digits automatically.

9. MaxSpread: Maximum Allowed Spread. Used for spread protection.

10. Parameter1 - Default value is recommended

11.  Parameter2 - Default value is recommended

12.  Parameter3 - Default value is recommended

13. Parameter4 - Default value is recommended

14. Parameter5 - Default value is recommended

15. Parameter6: 0 to 23 can be used.

16. Parameter7: 0 to 59 can be used.

17. Parameter8: 0 to 23 can be used.

18. Parameter9: 0 to 59 can be used.

nclick="viewGallery_GalleryManager.GoToPrev();"> nclick="viewGallery_GalleryManager.GoToPrev();">

ta itemprop="image" content="https://c.mql5.com/31/313/profit-ladder-mt5-ea-screen-1440.png" />

nclick="viewGallery_GalleryManager.GoTonext();"> nclick="viewGallery_GalleryManager.GoTonext();">